Question 1

How much does commercial epoxy flooring cost in Tampa?

Accepted Answer

Commercial epoxy flooring in Tampa Bay typically ranges from $3 to $8 per square foot installed, depending on floor size, slab condition, the coating system specified, and prep requirements. Floors requiring moisture mitigation or contamination remediation will be on the higher end. We provide fixed-price written quotes after a site assessment.

Question 2

How long does commercial epoxy flooring last?

Accepted Answer

A correctly installed commercial epoxy system on a properly prepared slab should last 10 to 20 years under normal commercial use. Lifespan depends primarily on prep quality, moisture management at installation, and the coating system selected. Floors that fail within 1 to 2 years almost always failed because of inadequate prep or unaddressed moisture.

Question 3

How long does installation take and what is the downtime?

Accepted Answer

A straightforward commercial installation on a clean slab runs approximately 2 to 3 days for prep and coating, plus 24 to 72 hours cure time before light foot traffic. Full cure for heavy forklift traffic is typically 7 days. Floors requiring moisture mitigation add 1 to 2 days. We schedule to minimize operational disruption and can work in phases on large floors to keep portions of the facility operational.

Question 4

Do you work with general contractors?

Accepted Answer

Yes. We work directly with GCs on new construction and renovation projects across Tampa Bay. We carry current liability insurance and can provide certificates of insurance, product data sheets, and installation documentation for project closeout packages.

Question 5

Can epoxy be installed over existing flooring or previous epoxy?

Accepted Answer

Existing flooring must be evaluated before any recoating. Failed or delaminating previous coatings must be fully removed before new coating is applied. Applying new epoxy over a failing system does not fix the underlying problem and will result in the same failure. Intact, well-bonded previous coatings can sometimes be recoated after proper preparation, but this depends on the compatibility of the systems and the condition of the existing surface.

Question 6

What is the difference between commercial and industrial epoxy flooring?

Accepted Answer

Commercial epoxy systems are specified for moderate to heavy foot traffic, occasional vehicle traffic, and standard chemical exposure. Industrial systems are designed for continuous forklift and heavy vehicle traffic, chemical immersion, impact resistance, and extreme loads. The distinction matters for system selection and thickness specification. If you're not sure which category your facility falls into, we assess this during the site visit.

Commercial Epoxy Flooring in Tampa, FL